Kaolin has been found to be a more economical alternative in ceramic hollow membrane fabrication compared to alumina, silica, and zirconia despite having similar properties. However, it was discovered that apart from having high mechanical strength and the ability to withstand high operational temperature, the kaolin membrane has the tendency to dissolve in a high alkaline solution. Hence, in this study, zirconia (ZrO2) was imposed to kaolin suspension as co-starting material due to its stable hexagonal properties with kaolin to overcome this drawback. To study the dissolution property of the modified kaolin-based membrane, a phase inversion technique was used to fabricate zirconia-kaolin hollow fiber membrane (ZKHFM) followed by immersion in ammonium hydroxide (NH4OH) as an alkaline solution. Ammonia was aptly chosen for it being considered as one of the pollutants to be removed from wastewater. The mechanism, morphology and properties of the membrane were investigated in terms of sin.....

775 hits

The adverse effects of ammonia found in wastewater streams lead to the development of advanced water treatment technology, i.e. membrane contactor (MC). In this study, single layer hollow fibre membrane (SLZK) and dual layer hollow fibre membrane (DLZK) were prepared from zirconia and kaolin and modified into hydrophobic membrane through simple grafting process via fluoroalkylsilane (FAS) agent. The properties of membranes such as morphology, surface roughness, mechanical strength, wettability and liquid entry pressure were analysed through scanning electron microscopy (SEM), atomic force microscopy (AFM), 3-point bending strength, contact angle and LEPw setup. Finally, the performance of the membranes was also investigated towards ammonia removal via membrane contactor system. Our findings showed that hydrophobicity properties significantly improved for both SLZK and DLZK membranes after grafting modification process as indicated by the increase of contact angle value from 5� and 1ï.....

413 hits

This research aimed to investigate the ultrafiltration of water from emulsified oily wastewater through the application of surface-functionalized ceramic membrane to enhance its water permeability based on optimized parameters using a cross-flow filtration system. The interactive effects of feed concentration (10?1000 ppm), pH (4?10), and pressure (0?3 bar) on the water flux and oil rejection were investigated. Central composite design (CCD) from response surface methodology (RSM) was employed for statistical analysis, modeling, and optimization of operating conditions. The analysis of variance (ANOVA) results showed that the oil rejection and water flux models were significant with p-values of 0.0001 and 0.0075, respectively. In addition, good correlation coefficients of 0.997 and 0.863 were obtained for the oil rejection and water flux models, respectively. The optimum conditions for pressure, pH, and feed concentration were found to be 1.5 bar, pH 8.97, and 10 ppm, respectively with.....

389 hits